Professional hvac installation services for homes and businesses in Sheridan and surrounding Wyoming communities.
A complete HVAC installation from KIC Refrigeration in Sheridan, WY addresses every element in the comfort chain, from the air handler and condensing unit to the thermostat, ductwork, and filtration system. We ensure proper airflow balance, verified refrigerant charge, tested safety controls, and code-compliant operation before turning the system over to you.
Properties throughout Sheridan (pop. 20,334) face unique demands when it comes to hvac installation. Wyoming heating loads, cooling calculations, and the insulation levels and duct configurations found in Sheridan homes all influence the approach we take. KIC Refrigeration tailors every hvac installation project to the conditions your property actually faces — no generic solutions.
Choosing the right contractor for hvac installation in Sheridan, WY makes all the difference between efficient comfort and a system that short-cycles. KIC Refrigeration uses Manual J load calculations, installs to manufacturer specifications, and backs every project with a warranty. Call (866) 858-2961 to schedule your free assessment.
How our NATE-certified technicians deliver quality hvac installation results from start to finish.
Our Sheridan estimator walks your property room by room — measuring square footage, checking insulation levels, assessing window area, and inspecting existing ductwork and electrical service. We input all variables into a Manual J load calculation to determine your exact heating and cooling requirements in BTU.
Based on load calculations and your priorities — efficiency, noise level, budget, zoning — we recommend specific equipment and provide a detailed written proposal covering equipment model numbers, SEER2/AFUE ratings, installation scope, warranty, and total cost.
KIC Refrigeration installs HVAC systems in Sheridan, WY to the highest standards. We set equipment on level, vibration-isolated mounting, braze all refrigerant connections with nitrogen flowing, pressure test with dry nitrogen, evacuate to below 500 microns, charge by weight, seal all duct connections with mastic, and verify gas piping sizing and connections.
Our Sheridan technician commissions the system by verifying superheat, subcooling, temperature split, static pressure, and gas pressure in heating mode. We program the thermostat, register your manufacturer warranty, label the electrical panel, and walk you through operation and maintenance.
Transparent answers about hvac installation from our certified technicians.
Complete HVAC installation in Sheridan ranges from $7,000 to $15,000 for a mid-efficiency furnace and AC combination — typically an 80 percent AFUE furnace paired with a 14.3 to 16 SEER2 condenser. High-efficiency systems with variable-speed blowers and two-stage or variable-speed compressors run $12,000 to $22,000 but deliver significantly lower operating costs and qualify for federal tax credits. Heat pump systems fall between $5,000 and $18,000 depending on whether the system is single-stage, variable-speed, or a dual-fuel configuration. Ductwork modifications or new duct runs add $1,000 to $5,000. KIC Refrigeration provides detailed written proposals for Sheridan homeowners with every cost itemized and no hidden fees.
Correct HVAC system sizing is determined by a Manual J residential load calculation — the ACCA industry standard — that accounts for your home square footage, ceiling height, insulation R-values, window area and U-factor, air infiltration rate, duct losses, occupancy, and the local WY winter and summer design temperatures. As a rough reference, a well-insulated 2,000-square-foot home in Sheridan typically needs a 2.5 to 3.5 ton system, while a poorly insulated home of the same size may need 4 tons. KIC Refrigeration never estimates by rule of thumb — we run a proper calculation for your specific Sheridan home to avoid oversizing, which causes short cycling, high humidity, and premature compressor wear.
A properly installed and maintained HVAC system in Sheridan typically lasts 15 to 20 years for the gas furnace and 12 to 18 years for the air conditioner or heat pump outdoor unit. Variable-speed equipment tends to last on the higher end of these ranges because it runs at reduced capacity most of the time, causing less thermal and mechanical stress on components. The three biggest factors in equipment lifespan are installation quality, annual professional maintenance, and regular filter changes every 1 to 3 months. KIC Refrigeration offers maintenance plans for Sheridan homeowners that include seasonal tune-ups, priority scheduling, and repair discounts to help you get the maximum life from your investment.
A standard furnace and AC replacement in Sheridan takes 1 to 2 days when existing ductwork, gas piping, and electrical service are adequate and the new equipment fits in the same location. A complete system replacement that includes ductwork modifications, new trunk lines, equipment relocation from basement to attic or vice versa, electrical panel upgrades, or zoning system installation may take 3 to 5 days. Multi-zone mini-split installations with 3 to 5 indoor heads typically take 2 to 3 days. KIC Refrigeration provides a clear timeline in every proposal, coordinates scheduling around your Sheridan home availability, and keeps you informed on progress every step of the way.
Our reputation is built on certified technicians, honest pricing, and results that last.
"KIC Refrigeration does our annual HVAC inspection every fall. They always find the small stuff before it becomes expensive. Peace of mind is worth it."
"Boiler kept cycling on and off. Technician found a faulty thermocouple and replaced it on the spot. No nonsense, no upselling. Just good honest work."
"Emergency repair on a Sunday night and they still showed up within the hour. Furnace was back up and running before bedtime. Lifesavers."